File:Seagate ST296N logic board jumper wires (detail).jpg
Summary
[edit | edit source].jpg&veaction=edit§ion=1){kind=link}
.jpg&action=edit§ion=1){kind=link}
Detail of the logic board of a Seagate ST296N 5.25-inch SCSI hard disk (board marked 20742-001 Rev B1). Fine red insulated wires run point to point on the component side: one from a via near the centre of the board, others to a surface-mount resistor and to pins of a Motorola 74LS196 counter, with spots of brown adhesive holding the wires to the board along their length.
Source
[edit | edit source].jpg&veaction=edit§ion=2){kind=link}
.jpg&action=edit§ion=2){kind=link}
Cropped from Wikimedia Commons, File:Seagate ST296N - PCB top view.jpg (retrieved 2026-10-25). The crop shows the area round the wires at full resolution.
Author
[edit | edit source].jpg&veaction=edit§ion=3){kind=link}
.jpg&action=edit§ion=3){kind=link}
Mister rf (Wikimedia Commons user), photograph dated 2021-12-01.
Licence
[edit | edit source].jpg&veaction=edit§ion=4){kind=link}
.jpg&action=edit§ion=4){kind=link}
Creative Commons Attribution-ShareAlike 4.0 International, as recorded on Wikimedia Commons. This crop is released under the same licence.
File history
Click on a date/time to view the file as it appeared at that time.
| Date/Time | Thumbnail | Dimensions | User | Comment | |
|---|---|---|---|---|---|
| current | 14:49, 25 October 2026 | | 2,129 × 753 (688 KB) | Josh (talk | contribs) | Upload for the PCB repair technique pages |
You cannot overwrite this file.
File usage
The following page uses this file:
.jpg&oldid=30900){kind=link}