PowerBook Duo 210 Backup Battery Replacement

The PowerBook Duo 210 and the other 68k Duos, the PowerBook Duo 230, PowerBook Duo 250, PowerBook Duo 270c, PowerBook Duo 280 and 280c, keep their clock and settings on a small backup battery that sits in the trackball assembly and plugs into the logic board by a lead.[1] Apple's user's guide for these machines describes two small backup batteries that keep the contents of memory for about four minutes while the main battery is changed, and keep the clock and control panel settings for up to two weeks after the main battery is flat or removed. It says they usually last several years.[2] Apple's specification calls it a 3 V lithium backup battery rated for 500 power cycles.[3] The pack in Pawel Pieczul's Duo 230 is two Sanyo ML2430 cells, each marked 3 V and RECHARGEABLE.[4] The PowerBook Duo 2300 has a different, single rechargeable cell, Apple part 922-1418.[5]
Symptoms
[edit | edit source]- Some control panel settings, such as the clock, are different after the main battery is taken out. Apple's chart says to replace the backup battery.[6][2]
- Open programs and documents are lost when the main battery is changed, even though the machine was put to sleep first.[2]
- The backup battery is also part of Apple's full power manager reset: if holding the rear power switch for 30 to 45 seconds does not cure a crash or power fault, remove the main battery, the adapter and the backup battery for 10 minutes, and the Duo reloads its power manager code from the system software.[7] In 1994 a Duo 250 owner reported on TidBITS that a battery that would not charge was cured only by unplugging the internal lithium battery for about 15 seconds with the main battery out, after the usual resets had failed.[8]
See PowerBook Duo Troubleshooting for other power faults.
Safety
[edit | edit source]Disconnect the power adapter and remove the main battery before starting; Apple warns that the logic board can be shorted otherwise.[9] Do not short the cells' terminals, and do not solder directly to a cell body; see Battery Refurbishment. If an old cell has leaked, see Battery Explosion, Capacitor or Corrosion Damage.
Tools and parts
[edit | edit source]- T-8 and T-10 Torx drivers, an IC extractor and a jeweller's flat-blade screwdriver; two small screwdrivers help with the battery connector.[9][8]
- Replacement cells. Like for like means two 3 V rechargeable ML2430 cells, as fitted at the factory.[4]
- Pieczul suggests two CR2430 or CR2032 cells instead.[4] Those are primary lithium cells, not made to be charged: Energizer rates its CR2032 for a maximum reverse charge of 1 µA.[10] Apple rates the original battery for 500 power cycles and the original cells are rechargeable, so read Battery Refurbishment#Coin cells, CMOS and RTC batteries before fitting primary cells.[3][4]
Procedure
[edit | edit source]Opening the computer
[edit | edit source]- Disconnect the power adapter, slide open the battery door and pull out the main battery.[9]
- Close and latch the computer, turn it over and remove the four case screws. Turn it upright and open the display.[9]
- Tilt the computer, lift the keyboard out onto the palm rest, push out the release tabs with a jeweller's screwdriver and disconnect the two keyboard cables.[9]
- Push off the left and right end clutch covers.[9]

- Raise the bottom left corner of the top case to release the snap and slide the case off its four interlocking tabs.[9]
Removing the backup battery
[edit | edit source]
- Lift the backup battery out of the trackball assembly.[1]
- Disconnect the backup battery cable from the logic board. The connector is very small; it unhooks by sliding it parallel to the board, pushing against its two wings with two small screwdrivers.[1][8]
Building the replacement
[edit | edit source]
- Before cutting anything, photograph the pack and record which coloured lead goes to which terminal of which cell. On Pieczul's pack there are three leads, red, black and white, to a three-pin connector.[4] The Service Source gives no wiring for the pack, so the original is the only reference.[1]
- Keep the lead and its connector. Remove the old cells.
- Connect the new cells exactly as the old ones were connected, using cells with welded tabs. Do not solder to the cell bodies. See Battery Refurbishment#Step 5: Map the pack before you cut anything.
- Insulate every exposed tab and joint, and wrap the pack so that it fits the recess in the trackball assembly as the original did.[1]
Refitting
[edit | edit source]- Connect the backup battery cable to the logic board and seat the battery in the trackball assembly.[1]

- Route the backup battery cable around the trackball, as Apple does when refitting the trackball assembly. Apple's chart lists a cable fouling the trackball as a cause of a cursor that will not move.[11]
- Refit the top case, end clutch covers and keyboard. Do not overtighten the four case screws: Apple warns that this warps the keyboard and restricts key movement.[9]
- Refit the main battery and connect the adapter.[9]
Testing
[edit | edit source]- Switch on and set the date, time and control panels, which are lost while the backup battery is disconnected.[2]
- Put the machine to sleep and change the main battery. The settings, and the open documents if the change takes less than about four minutes, should survive.[2]
- If the machine will not start or behaves oddly after the work, reset the power manager by holding the rear power switch for 30 to 45 seconds.[7]
Related pages
[edit | edit source]- PowerBook Duo 210, PowerBook Duo 230, PowerBook Duo 250, PowerBook Duo 270c, PowerBook Duo 280
- PowerBook Duo 210 Trackball Repair
- PowerBook Duo General Maintenance
- PowerBook Duo Troubleshooting
- Battery Refurbishment
- PowerBook Duo 200 Series Service Source
References
[edit | edit source]- ↑ 1.0 1.1 1.2 1.3 1.4 1.5 Apple Computer, PowerBook 200 Series Service Source, Take Apart, Backup Battery pp. 19-21 (PDF pp. 93-95): remove the backup battery from the trackball assembly; carefully disconnect the backup battery cable from the logic board. Hosted as File:PowerBook Duo 200 Series Service Source.pdf; see PowerBook Duo 200 Series Service Source.
- ↑ 2.0 2.1 2.2 2.3 2.4 Apple Computer, PowerBook User's Guide for PowerBook Duo computers (1993), chapter 6, Power Management, pp. 93-96: backup batteries protect main memory for about 4 minutes while the main battery is replaced and keep other information, including control panel settings such as the clock, for up to 2 weeks; the computer has two small backup batteries that usually last several years; replace them if system settings change after the main battery is removed; Apple's instruction is that an Apple-authorised service provider replaces them. Archive.org item manualzz-id-1316791.
- ↑ 3.0 3.1 Apple Computer, PowerBook 200 Series Service Source, Specifications, Electrical p. 13 (PDF p. 25): PRAM battery, 3 V lithium backup battery, 500 power cycles capacity; Memory p. 5 (PDF p. 17): clock/calendar chip supported by a long-life lithium battery.
- ↑ 4.0 4.1 4.2 4.3 4.4 Pawel Pieczul, "Apple Macintosh Powerbook Duo 230", Old Crap Vintage Computing, 5 April 2020 (retrieved 2026-10-25): photographs of the backup battery, two stacked cells marked SANYO ML2430 3V RECHARGEABLE with red, black and white leads to a three-pin connector; the text says the original backup battery is two rechargeable ML2430 cells and suggests replacing them with two CR2430 or CR2032 cells soldered together. Community teardown.
- ↑ Apple Computer, PowerBook 2300 Series Service Source, Specifications, Memory p. 3 (PDF p. 16): clock/calendar with long-life rechargeable lithium battery; Exploded View (PDF p. 210): backup battery 922-1418. Hosted as File:PowerBook Duo 2300c Service Source.pdf.
- ↑ Apple Computer, PowerBook 200 Series Service Source, Troubleshooting, Symptom Charts/Power (Continued) p. 7 (PDF p. 35): after you remove the main battery, some Control Panel settings are different: replace backup battery.
- ↑ 7.0 7.1 Apple Computer, PowerBook 200 Series Service Source, Troubleshooting, Power Manager Reset p. 3 (PDF p. 31).
- ↑ 8.0 8.1 8.2 "Duo Charges Refused", TidBITS, 17 January 1994 (retrieved 2026-10-25): a Duo 250 that would not charge its battery; the fix was to remove the external battery and unplug the internal lithium battery for about 15 seconds; the keyboard is removed by taking out the three screws towards the back with a Torx T8; the connector sits under the right end of the space bar and has three multicoloured wires; it unhooks by motion parallel to the circuit board, pushing against its two wings with two small screwdrivers. Contemporary user report.
- ↑ 9.0 9.1 9.2 9.3 9.4 9.5 9.6 9.7 9.8 Apple Computer, PowerBook 200 Series Service Source, Take Apart: Main Battery p. 1, Keyboard pp. 2-7, End Clutch Covers pp. 8-9, Top Case pp. 10-13 (PDF pp. 75-87).
- ↑ Energizer, "CR2032 product datasheet" (retrieved 2026-10-25): lithium coin, 3.0 V, 235 mAh; max reverse charge 1 microampere.
- ↑ Apple Computer, PowerBook 200 Series Service Source, Take Apart, Trackball p. 25 (PDF p. 99): route the display switch cable and the backup battery cable around the trackball; Troubleshooting, Peripherals p. 28 (PDF p. 56): make sure the display switch cable and battery cable are not impeding the trackball.