Jump to content

Apple AppleVision 850 Display

From RetroTechCollection
AppleVision 850 Display
AppleVision 850 Display (Apple Service Source)
Apple's illustration of the AppleVision 850 (Service Source)
Manufacturer Apple Computer, Inc.
Type 20-inch multiple-scan Trinitron colour monitor
Release date 1997
Interface 15-pin miniature D-type video with separate sync and DDC, combined video/ADB cable; VGA adapter
Dimensions 474 × 484 × 515 mm (H × W × D)
Weight 30 kg (67 lb)
Model M6162LL/A (order number of the 20-inch ColorSync Display, 1998)
Power 90-264 V AC, 47-63 Hz, 150 W maximum
Resolution 640 × 480 to 1600 × 1200

The AppleVision 850 Display is a 20-inch Trinitron monitor with a 19.0-inch viewable image that Apple introduced in 1997 as its high-end two-page display. It runs at resolutions from 640 × 480 up to 1600 × 1200, Apart from brightness and contrast, its picture, geometry and colour are set from the Macintosh through the AppleVision software.[1][2] In November 1997 Apple renamed it the 20" (19.0" VIS) ColorSync Display; the name was the only change.[2] The AppleVision 850AV is the same display with a speaker enclosure and a microphone.

Specifications

[edit | edit source]
AppleVision 850 specifications[3]
Item Value
Picture tube 20-inch Trinitron, 19.0-inch viewable image; 0.26 mm stripe pitch, 0.25 mm grille pitch; multilayer anti-reflection panel
Preset resolutions 640 × 480 at 60, 67, 72, 75 and 85 Hz; 800 × 600 at 56-85 Hz; 832 × 624 at 75 Hz; 1024 × 768 at 60-85 Hz and 87 Hz interlaced; 1152 × 870 at 75 Hz; 1280 × 1024 at 75 and 85 Hz; 1600 × 1200 at 75 Hz
Scan rates Vertical 48-120 Hz; horizontal 30-94 kHz
Input RGB with separate sync, DDC clock and data; video/ADB cable with a VGA adapter
Ports Two ADB pass-through ports
Degauss Automatic at power-on; manual by switching off and on
Power 90-264 V AC, 47-63 Hz; 150 W maximum
Stand Tilt −5° to +15°; swivel at least ±45°
Size and weight 474 mm high, 484 mm wide, 515 mm deep (± 3 mm); 30 kg (67 lb)
Operating environment 10-40 °C; 20-95% humidity, non-condensing; up to 3,048 m (10,000 ft)

Apple's August 1997 product guide gives 18.7 × 19.1 × 20.2 in and 67.4 lb (30.6 kg); the 1998 data sheet bound into the Service Source gives 30.6 kg and the order number M6162LL/A for the renamed 20-inch ColorSync Display.[1][3] The AppleVision software needs a 68040 or later processor and System 7.1 or later.[3]

Software control

[edit | edit source]

There are no internal geometry or colour controls for the user. Brightness and contrast are on the front panel; everything else (geometry, convergence, colour and white point) is set through the Monitors & Sound control panel, which talks to the display over ADB. Apple's service manual stresses that the display's ADB and video cables must both be connected to the computer.[4] The user's manual says the power light is green in use and amber in energy-saving mode, and that restarting with Command-Option-A-V held down resets the display to its factory settings.[5] The display's set-up data lives on its CRT/video board, and Apple's service procedures read and write it with the Display Service Utility.[2]

Hardware

[edit | edit source]

Both the 850 and the 850AV use the same main deflection board (661-1213) and CRT/video board (661-1312). The 850 has an ADB board (922-2727) in its bottom housing and a blank plate where the 850AV has its microphone.[6] From January 1998 the 20-inch ColorSync Display (not the AV model) was built with TCO 95 plastics, marked on the rear housing, which Apple replaces like for like.[2]

The CRT anode runs at 27 kV.[7] Follow the CRT Discharge Procedure before working inside.

Known faults

[edit | edit source]
  • Apple's service manual notes that many modules returned for repair worked, and puts set-up, software and environmental checks first.[4]
  • A screen that freezes at startup, and corrupted set-up data, can be caused by the yoke wires to BF1 and BL1 on the main deflection board being clamped in with the ribbon cables.[4]
  • One owner's 850AV would only display properly at 1024 × 768 and 60 Hz, giving a narrow, distorted picture in other modes; capacitors, the sync processor (a TDA4858 on the neck board) and its supply were checked without curing it. Another owner with an AppleVision 1710 found a similar fault in the control logic on the neck board and cleared it with new capacitors in the digital section and a blank 93C66 EEPROM, after which the display behaved as a plain multiple-scan monitor.[8]

Maintenance and repair

[edit | edit source]

Documentation

[edit | edit source]
[edit | edit source]
[edit | edit source]

References

[edit | edit source]
  1. ↑ 1.0 1.1 Apple Computer, Apple Facts 8.97, August 1997: introduction of the AppleVision 850 and 850AV as new two-page displays, and the AppleVision 850 and 850AV entries, pp. 114-115. archive.org item applefacts8.97august1997ocr.
  2. ↑ 2.0 2.1 2.2 2.3 Apple Computer, 20" ColorSync Displays (Service Source), hosted as File:Colorsync 20 displays.pdf. Basics: product name change p. 1, overview pp. 2-4, Display Service Utility pp. 5-6, TCO 95 housing p. 7 (PDF pp. 8-14).
  3. ↑ 3.0 3.1 3.2 20" ColorSync Displays Service Source, Specifications, pp. 2-23 (PDF pp. 17-38), and Apple ColorSync Displays data sheet L02722C, May 1998 (PDF pp. 39-40).
  4. ↑ 4.0 4.1 4.2 20" ColorSync Displays Service Source, Troubleshooting, First Checklist and Symptom Charts, pp. 2-9 (PDF pp. 43-50).
  5. ↑ 5.0 5.1 Apple Computer, AppleVision 850 and 850AV Displays User's Manual, hosted as File:AppleVision 850 and 850AV Displays Users Manual.pdf. Setting up chapter 1 (PDF pp. 1-24); tips and troubleshooting chapter 5 (PDF pp. 65-80).
  6. ↑ 20" ColorSync Displays Service Source, Exploded View (PDF p. 177).
  7. ↑ 20" ColorSync Displays Service Source, Troubleshooting, Checking High Voltage, pp. 18-19 (PDF pp. 59-60).
  8. ↑ AppleVision 850AV Repair, TinkerDifferent forum (Elemenoh, marmotta and others), 2022-11 to 2024-01—link(accessed 2026-10-02) Community repair thread with a capacitor list for the main deflection board.